Mechanical Coupling

Fusion Mechanical Join HDPE / PPR :

• Simple, Fast, easy bolted connection.
• Eliminates Butt Wedding.
• Eliminate socket fusion welding.
• Fast installation.
• Economical- A Union at every joint, hence reduce the cost of flange assembly.
• Easy to remove and rotate pipe for increase pipe life.
• No special tool required (Jack, Mirror, Electricity)
• Pressure: 4 Kgf to 16 Kgf.
  

The Yeekay Technocrat (P) Ltd. (Fusion) proud to introduce mechanical coupling system for HDPE and PPR pipe jointing system.

Economy : Fusion Mechanical Coupling design and developed to reduce the cost and time for installation. It avoid flange assembly as itself is a union at every joint.

Housing : Made of durable plastic for rugged service condition.

SS Teeth : Integral gripping teeth made of stainless steel inserts and molded, provide direct connection to the pipe.

Rubber Gasket : Elastomer gasket with triple seal design provides a leak free seal.

1. EPDM : Recommended for hot water service
   
   Temperature -30ºC to +85ºC
   Temperature Rating -34ºC to +110ºC

2. Nitrile : Recommended for petroleum products, hydrocarbon, air with oil vapors, vegetables and mineral oil.
   Temperature -29ºC to +82ºC

Always check gasket supplied before application.

Comparison of jointing system :

Traditional heat fusion system Vs Fusion Mechanical Joint System

Traditional Heat Fusing System	Fusion Mechanical Joint System
Equipment required: Heater, Hydraulic Jack, Knife and Electricity.	Equipment required: Only Ring Spanner
Heat On- Time	Positioning the Gasket
Positioning Pipe in Hydraulic Jack	Fit the Housing with fastener.
Tightening pipe in jack
Positioning Pipe and Heat the Pipe- Time consumption
Remove the Heater and Join Pipe
Clean the joint with knife and wait for cooling the pipe- Time consumption
Unlock the Jack and remove the pipe

Fusion Pressure Fittings :